plustek: primax and plustek-module-42-5
Subject:
Re: primax and plustek-module-42-5
From:
"Jaeger, Gerhard" ####@####.####
Date:
15 Mar 2002 17:36:18 -0000
Message-Id: <16lvWh-1GAHwWC@fmrl11.sul.t-online.com>
It may happen, that the memory test fails.
I had one device in the past, where the memory was at least
defective...
You are right, the ASIC is detected, but the memory
test normally checks the communication...
You may also try slowIO=1...
The memory-test bypass may also work!
Gerhard
On Friday, 15. March 2002 12:36, a.brotzmann wrote:
> Am Donnerstag, 14. März 2002 21:33 schrieben Sie:
> > This looks like a communication problem so far.
> > You might set you parport in the BIOS to SPP and
> > if this works to EPP, do not use the ECP.
> >
> > This may help.
> > Gerhard
>
> No, does not work. I've opened the cover of the scanner and found a chip
> "P96001" so i assume the ASIC-Detection works. The only problem is the
> memorycheck. In SPP-Mode it fails at position 0 and in EPP-Mode at position
> 256. I tryed ECP as well with the same result as in EPP-Mode. I've tested
> all Modes with and without slowIO. It is always the same Problem:
> memorycheck failes at pos 0 or at pos 256. Today i will try to bypass the
> memorycheck in the driver to see if this works or do you have any
> suggestion that may help.
>
> CU
> Brotzmann, Andreas
