| Previous by date: | 29 May 2005 16:06:01 +0100 Re: [gnupic] help - DIY PCB manufacture, Alex Holden |
| Next by date: | 29 May 2005 16:06:01 +0100 Re: [gnupic] help - DIY PCB manufacture, niv levy |
| Previous in thread: | 29 May 2005 16:06:01 +0100 Re: [gnupic] help - DIY PCB manufacture, Alex Holden |
| Next in thread: | 29 May 2005 16:06:01 +0100 Re: [gnupic] help - DIY PCB manufacture, niv levy |
On Mon, 30 May 2005 01:47:52 +1200, David McNab ####@####.#### wrote: > I need some advice on home PCB manufacture. I went down this road a few years ago. It is cheap, but as you found out, the quality of those iron-ons is not meant for thin traces. I found that anything smaller than 50mil causes problems. You should be able to repair broken etched 25mil traces with a thin soldering iron, a magnifier and wire-wrap wire. I ended up making many boards just to get a few good ones. You can get good prototypes from many circuit board shops but the minimum final cost is in the range of $60 (shipped to you). I have used http://apcircuits.com/ Others have suggested: http://www.olimex.com/pcb/ http://www.iqcircuits.com/ I also use pcb http://bach.ece.jhu.edu/~haceaton/pcb/ (it is totally free). Best regards, Anthony Tekatch http://www.unihedron.com/
| Previous by date: | 29 May 2005 16:06:01 +0100 Re: [gnupic] help - DIY PCB manufacture, Alex Holden |
| Next by date: | 29 May 2005 16:06:01 +0100 Re: [gnupic] help - DIY PCB manufacture, niv levy |
| Previous in thread: | 29 May 2005 16:06:01 +0100 Re: [gnupic] help - DIY PCB manufacture, Alex Holden |
| Next in thread: | 29 May 2005 16:06:01 +0100 Re: [gnupic] help - DIY PCB manufacture, niv levy |