gnupic: Re: [gnupic] Serial programmer for USB parts?
Subject:
Re: [gnupic] Serial programmer for USB parts?
From:
Xiaofan Chen ####@####.####
Date:
30 Jan 2006 04:08:09 +0000
Message-Id: <a276da400601292007y511114a8y70e8def155a74537@mail.gmail.com>
On 1/30/06, Robert Wohleb ####@####.#### wrote:
> Has anyone had much luck with SDCC and USB on the PIC18F USB chips?
>
> ~Rob
Try the following link. It is built with an old version of SDCC but it
can be built with later version of SDCC after a bit of tweaks.
Regards,
Xiaofan
On 12/15/05, Timothy Gale ####@####.#### wrote:
> Hi Olin,
>
> I'm not sure whether this will be exactly what you want, but over the
> past little while I've been playing with the 2550 and written a C
> library for SDCC. It's available for download here:
> http://www.geocities.com/tegale2001/downloads/pickit2.tar.gz
>
> usb.c and comms.c are the places where the main USB work is done.
> Unfortunately, no support for interrupt pipes as yet, but bulk ones
> appear to go pretty well (using linux here for the client). As
> suggested by the filename, it's intended for the PICkit 2 - the goal is
> to get STDP for dspics working, but unfortunately at the moment it
> doesn't seem to be working, whether due to not entering the mode or not
> recognising commands I'm not sure. If anyone figures out what's wrong,
> I'd be very grateful!
>
> Hope this is of some use
> Tim
>
> PS SDCC version used was from about June - not sure whether the current
> one will still work
>
