gnupic: Re: [gnupic] pk2 v2.00 beta
Subject:
Re: [gnupic] pk2 v2.00 beta
From:
"Xiaofan Chen" ####@####.####
Date:
26 Jun 2006 14:25:19 +0100
Message-Id: <a276da400606260625jaf5793ap7d4828119f866d0d@mail.gmail.com>
Hi Jeff,
There is a minor problem with 16F684 User ID. It fails to write the
user id and -verify failes to check this error.
Regards,
Xiaofan
####@####.#### ./pk2 -device=16F684
-write state6842EEprom.hex
PK2 version 2.00 beta 1 - 2006/06/24
./pk2 -device=16F684 -write state6842EEprom.hex
Locating USB Microchip PICkit2 (vendor 0x04d8/product 0x0033)
Found USB PICkit as device '008' on USB bus 001
Communication established. PICkit2 firmware version is 1.20.0
Using PIC16F684
Erasing device...
Writing program...
Writing eeprom...
File state6842EEprom.hex written to device
####@####.#### ./pk2 -device=16F684
-verify state6842EEprom.hex
PK2 version 2.00 beta 1 - 2006/06/24
./pk2 -device=16F684 -verify state6842EEprom.hex
Locating USB Microchip PICkit2 (vendor 0x04d8/product 0x0033)
Found USB PICkit as device '008' on USB bus 001
Communication established. PICkit2 firmware version is 1.20.0
Using PIC16F684
Reading program...
Reading eeprom...
Comparing 2048 words program
Comparing 256 bytes eeprom
Program errors 0
EEPROM errors 0
config word 1 ok: 0x30c4, mask 0x0fff
config word 2 ok: 0x21a4, mask 0x0000
####@####.#### piklab-prog -p
pickit2 -d 16F684 -c verify state6842EEprom.hex
Piklab version: 0.10.0 (rev. 1143)
libusb 0.1.10a: using bulk mode
Connecting PICkit2 on USB Port with device 16F684...
Firmware version is 1.20.0
Set target self powered: false
Connected
Read id: 16F684 (rev. 3)
Verifying...
Verify memory: Configuration Bits
Verify memory: User IDs
Device memory does not match hex file (in User IDs at address 0x2001:
reading 0x0000 and expecting 0x0001).