gnupic: gputils 0.13.6


Previous by date: 16 May 2008 18:51:37 -0000 Re: [gnupic] P18F45K20 support, David
Next by date: 16 May 2008 18:51:37 -0000 Re: [gnupic] Cod file question, Phil
Previous in thread: 16 May 2008 18:51:37 -0000 Re: gputils 0.13.6, Tim Stahlhut
Next in thread:

Subject: Re: gputils 0.13.6
From: David ####@####.####
Date: 16 May 2008 18:51:37 -0000
Message-Id: <20080516153124.4b948845@DEEPTHOUGHT.BARNET.net>

On Wed, 14 May 2008 20:39:00 -0400
David ####@####.#### wrote:

I've added a few processors, and it doesn't seem like there are any
*small* last-minute patches or fixes, so consider this a last call. I'm
planning on pulling 0.13.6 together sometime tomorrow.

Here's the updated list of supported processors:
18f2321, 18f2450, 18f2523, 18f4321, 18f4450, 18f45k20, 18f65j50,
p18f66j60, p18f66j65, p18f67j60, p18f86j60, p18f86j65, p18f87j60,
p18f96j60, p18f96j65, and p18f97j60

David

> Hi guys,
> 
> I've knocked out all the bugs I was planning on fixing before
> releasing gputils 0.13.6. I'm planning on wrapping up the release
> this week, so if you have any *small* last-minute patches or fixes
> that you want included, send me an email ASAP and let me know when
> you'll have them ready. This would be a good time to add support for
> your favorite processor if it's not included yet:
>   http://gputils.wiki.sourceforge.net/HowToAddProcessors
> 
> Here's a list of significant changes in this release:
> - new processors: 18f2321, 18f2450, 18f2523, 18f4450, p18f66j60,
> p18f66j65, p18f67j60, p18f86j60, p18f86j65, p18f87j60, p18f96j60,
> p18f96j65, and p18f97j60
> - support new COFF format across all of gputils
> - support CODE_PACK directive
> - updated CONFIG directive definitions to match MPASM 5.20
> 
> There have also been a whole lot of bugs fixed.
> 
> David

Previous by date: 16 May 2008 18:51:37 -0000 Re: [gnupic] P18F45K20 support, David
Next by date: 16 May 2008 18:51:37 -0000 Re: [gnupic] Cod file question, Phil
Previous in thread: 16 May 2008 18:51:37 -0000 Re: gputils 0.13.6, Tim Stahlhut
Next in thread:


Powered by ezmlm-browse 0.20.