gnupic: pk2cmd + pic18f4550
Subject:
pk2cmd + pic18f4550
From:
august ####@####.####
Date:
28 Sep 2008 14:11:48 -0000
Message-Id: <20080928141145.GA22673@alien.mur.at>
Hi,
I was wondering if anyone has had any experience using the pickit2
and pk2cmd under linux? I just got one, thinking I could program
my device [http://www.create.ucsb.edu/~dano/CUI] in circuit. I
connect the pickit2 to the board using a cable I built , and double
and triple checked the connection. I can do:
>>>pk2cmd -PPIC18F4550 -I
>>>Device ID = 1202
and ...I see that the device is connected. But, when I erase and
then check the memory, it always says:
>>>pk2cmd -PPIC18F4550 -E
>>>Erasing Device...
>>>Operation Succeeded
>>>pk2cmd -PPIC18F4550 -C
>>>Configuration memory is NOT blank.
>>>Address Good Bad
>>>300000 000500 000000
>>>Operation Succeeded
I don't understand the output. It says the operation succeeded, but
prints out memory errors. Ultimately, I cannot write a .hex file to
the device.
Does the latest pk2cmd 1.12 with the 2.32 firmware work under linux?
Any suggestions?
many thanks - august.
