gnupic: Which programmer for 16F87X?
Subject:
Re: Which programmer for 16F87X?
From:
####@####.####
Date:
12 Sep 2001 22:10:03 -0000
Message-Id: <001301c13bd5$e3280c50$41c84dd5@marek>
> No. All of the control signals going to the PIC should pass through the
573
> as shown in the schematic. If you bypass the 573 for RB3/Vcc then you'll
> run into the 3.3V problem again.
RB3 goes through 573 and the voltage is sometimes falling, but this problem
is eliminated :( Programmer doesn't work with 5v LPT.
Software seems OK (checked over half a night)...
The LPT cable now has 10cm only...
Power source (+5V) very clean...
Any suggestions?
> BAJ
>
> P.S. Question for Scott/Craig: Any objections to this thread on the
mailing
> list? Andy set up a Mailing list for picprg2.3 but it seems the questions
> are coming here to gnupic.
Can you give an addr for it?
jerry
####@####.####
