plustek: OpticPro96000P - Installation problem
Subject:
Re: OpticPro96000P - Installation problem
From:
"Jaeger, Gerhard" ####@####.####
Date:
12 May 2002 08:36:57 -0000
Message-Id: <176og3-1yQ3wOC@fmrl04.sul.t-online.com>
On Saturday, 11. May 2002 19:26, Burkhard Kayser wrote:
[SNIP]
> Try to claim the parport
> parport-modi: SPP PS/2 EPP EPP(ECP) PS/2(ECP)
> Using EPP-mode
> Starting Scanner-Autodetection
[SNAP]
> ModelSet4830() done.
> p48xxDoTest()
> Bank 0 overwritten
> found 0 bytes of memory
> No memory ! No scanner...
> p48xxReadWriteTest()
> Found a 96003 ASIC at Reg 0x13
> ModelSet4830()
> modelInitPageSettings()
> A4 set
> ModelSet4830() done.
> p48xxDoTest()
.
.
.
[SNAP]
Same old story here again....
Try and set the BIOS to plain EPP or try SPP...
The memory read/write test fails and that's why your scanner
is not recognized anymore. Why this happens while only changing
the distro-version, I don't know - or did you change your HW too?
You might set the port to SPP in BIOS and use afterwards the forceMode=2
switch to use the EPP mode anyway...
Hope this helps
Gerhard
-------------------------
gerhard AT gjaeger DOT de
